Novosele in a month

QUESTION: Why the karkasno-panel board house fast is under construction?
The answer: First of all it is very easy for designing. It concerns both the general lay-out, and a lay-out of separate premises, definition of places for windows and doors, and also a covering of outside walls, placing of home appliances and other equipment. Also it is possible to vary purposefully both heat conductivity, and sound insulation depending on requirements of the customer. Thus the thickness of walls remins enough small and saves approximately 10 % of a floor space. Frame walls can sustain unlimited number of cycles freezing — thawing. The covering from TSSP (it is cement-struzhechnaja a plate) supplies protection against fire and a moisture. Material inputs on a structure of frame walls the most minimum. And, the most important thing, thanks to easy "dry" technology of assemblage is essentially reduced term of introduction of the house in operation. At well organised works to drive to the frame house it is possible in a month after the building beginning.

QUESTION: How to warm the frame house?
The answer: polyfoam, minvata, minplita and others easy teploizolyatsionnyie materials with which internal spaces of walls are filled in Is used. The given materials have the lowest heat conductivity. Thanks to it at the general thickness of a wall of all in 200-250 mm, their resistance to an outside cold it is equivalent to the brick wall having a thickness of 2 metres!

QUESTION: What service life of karkasno-panel board houses?
The answer: It is considered, that frame houses serve no more than 30 years. However practice has shown, that application of modern materials and technologies increases term of their operation till 50-70 years and more.

QUESTION: On what bases karkasno-panel board houses are erected?
The answer: As frame walls the lungs from all known also have as of today high degree of stability to deformations, they can be built on stolbchatyih the bases or the bases «floating columns».

QUESTION: What should be parametres of racks of a skeleton?
The answer: skeleton Racks should be height 250-300 see Put them on corners and on walls through each of 70-80 sm, and also on either side of all doors and windows. Racks fasten cuttings or thorns. Width of boards for racks not less than 10 sm because it will define a thickness of the future walls. Before to put bottom obvyazku, the base isolate two layers of roofing material.

QUESTION: How the frame house in some floors is under construction?
The answer: Assemblage is made poetazhno: ground floor walls fasten to the prepared ledge of the base, are fastened among themselves, and also from above horizontal obvyazkoy. Then the ceiling designs forming a support for assemblage of a following floor by the same principle are established. Draught assemblage of the panel board house under such scheme is made for 2-3 days, including installation of a roof for protection against a rain.
Further the basic design is completed with boards. Then it is necessary to tax panel board panels with a heater, and on an inside of walls to put paroizolyatsiyu. It largely will protect from occurrence of the condensate getting from a premise. Internal furnish is executed more often by plaster panels or a wooden covering.

QUESTION: What defects of frame walls?
The answer: Walls from a tree easily ignite and are subject to action of insects — wreckers and to rotting that is why require special processing and constructive protection against a moisture and fire. Vagonka — the basic material for a covering of frame walls fast (within 1-2 years) cracks, on a wall there are cracks (at correctly executed works — not through). The increase in the sizes of the house (L walls> 9 m, height> 2 floors) leads to significant complication of a skeleton and reliability decrease. Source: the Newspaper "Building" #25 (2004) heading «Stroyinform»

It is introduced: on April, 20th, 2007

Komfortno and warmly in the wooden house
QUESTION: In what of dignity of wooden walls?The answer: Wooden walls have low heat conductivity. Therefore, if in the winter the house was not heated, to warm up it to comfortable conditions it is possible in some hours. The tree creates a healthy microclimate in the house, superfluous humidity is fast removed from a premise. Walls from a tree are...
Bitumnaya a tile, Ondulin — well checked up new
QUESTION: What does the bitumen tile represent?The answer: Any more the one ten years occurs in architecture and building concept «a bitumen tile». It is a version of the soft roofing material which has united in of property of a ceramic tile, wooden gonta (the invoice, appearance) and rolled roofing materials which supply plasticity and high gluing ability.QUESTION: What firm...
Mastika will make a roof seamless
QUESTION: For what mastics are intended?The answer: Bitumno-polymeric and polymeric mastics are applied both to the system of new seamless roofs, and for repair of all kinds of old roofs. By means of mastics there is a special elastic type of a roof. They are put in the liquid state on a surface and form the waterproofing film differing from...
The wooden house
 Tree - most ecologically pure and natural material. In building the tree is very widely used and in some cases it is possible to tell simply not zamenimo. Also it seemed, that can be better, than live in the wooden house, the tree breathes, very good microclimate, wood - an easy material creates in the house and is simply enough...
The wooden house
 Tree - most ecologically pure and natural material. In building the tree is very widely used and in some cases it is possible to tell simply not zamenimo. Also it seemed, that can be better, than live in the wooden house, the tree breathes, very good microclimate, wood - an easy material creates in the house and is simply enough...
The wooden house
 Tree - most ecologically pure and natural material. In building the tree is very widely used and in some cases it is possible to tell simply not zamenimo. Also it seemed, that can be better, than live in the wooden house, the tree breathes, very good microclimate, wood - an easy material creates in the house and is simply enough...
Betonosmesiteli SBR-320 SBR-430
Betonosmesiteli SBR-320 and SBR-430 are intended for preparation of building solutions and concrete mixes, and also for mixing of dry mixes. Technical characteristics betonosmesiteley SBR-320 and SBR-430  betonosmesitel SBR-320betonosmesitel SBR-430SBR-320 SBR-430Geometrical volumeDrum, l320430...
Nadezhnost above if the roof "breathes"
QUESTION: What is the "breathing" roofs?The answer: Unlike a habitual method of stacking of a roofing carpet (continuous prikleyki rolls to the basis), sometimes materials are expedient for stacking, using so-called partial prikleyku. Thereby conditions for occurrence of redundant pressure owing to formation of an air backlash between a roof and the basis are excluded. The roofs executed in such...
Nadezhnost above if the roof "breathes"
QUESTION: What is the "breathing" roofs?The answer: Unlike a habitual method of stacking of a roofing carpet (continuous prikleyki rolls to the basis), sometimes materials are expedient for stacking, using so-called partial prikleyku. Thereby conditions for occurrence of redundant pressure owing to formation of an air backlash between a roof and the basis are excluded. The roofs executed in such...
Betonosmesitel SBR-50
 Betonosmesitel SBR-50 it is intended for preparation of building solutions and concrete mixes, and also for mixing of dry mixes. Technical characteristics betonosmesitelya SBR-50 Technical characteristicsbetonosmesitel SBR-50SBR-50The geometrical size of a drum, l50Volume ready zamesa25...
Smesitelnyiy the block
 The block mixing BS-1500 is intended for preparation of concrete mixes, building solutions, and also hashing of dry components in processing lines of factories of precast concrete, betonorastvornyih factories, betonosmesitelnyih installations. Blocks mixing BS-1500 in areas with a temperate climate are maintained at temperature of air from +40 With to +4 With.BS-1500The basic specifications of amalgamator BS-1500-04.00.000 The indiator nameUnits of...
Metallocherepitsa — a roof of a new century
QUESTION: What metal tile production process?The answer: the New roofing sheet material is development of idea of a corrugated sheet towards increase of its aesthetic qualities. For this purpose zinced or aluminium krupnorazmernyiy the sheet is stamped on a plot of a tile roof of a different profile and covered with anticorrosive structure from both parties. Then the face sheet...
Vidyi drank-materials
More often in shops and on lesobazah already dried wood is sold, and crude — meets seldom enough. Depending on that you wish to make and on what wood was necessary for you, you can acquire a range or integral round wood, podvyaznik, a pole, plates, quarter timbers, lezhen, a bar, an edging board, plywood or an interline interval.  Kinds...