Betonnyie floors it is done by the warm

All systems of electric cable heating, irrespective of appointment, whether it be only comfortable heating or complete heating of a premise, are mounted by one principle.
nVyibiraetsya a temperature regulator installation site. The temperature regulator can be established on a wall in any convenient place, at any height. At installation of heating systems of a floor in premises with the raised humidity a temperature regulator bear in a dry premise. After a choice of an installation site of a temperature regulator it is made pododka to this place of the power supply and it is done shtroba under a current carrying wire of a heating cable and a temperature-sensitive element.
On a concrete plate the heat insulator «Hanalon», representing penopropilen, covered with two parties a foil protected by a thin layer of polymer keeps within. It is very important, that over a foil there is a protective layer as at its absence the free alkali containing in a cement mortal, in a short time "will corrode" aluminium.
Over a heat insulator the assembly tape with step 40-60 keeps within It see fastens to a floor dyubelyami, attaching at the same time and «Hanalon».
Further on a floor with settlement step the cable keeps within and is fixed on a tape available on it homutikami. A step homutikov 25 mm. The step of coils of a cable settles up under the formula: h = Sx100/L, where h – a step between coils, (sm), S – the area of stacking of a cable, (m2), L – length of a cable ().
The length of a cable, electric resistance and capacity – are indicated on a label pasted to connecting mufte of a cable which before pouring by a solution should be removed and pasted in the passport. The offered formula and detailed instructions on installation contain in the passport applied on each cable.
For the control over system work its structure includes a temperature regulator with the gauge. The gauge keeps within in the goffered tube in diameter less than 16 mm between cable coils so that it has appeared in an open loop. The tube end is muffled in order to avoid solution hit. The goffered tube necessarily passes on a wall to the temperature regulator. Such technology of stacking of the gauge allows to replace easily it in case of malfunction.
Wires from a cable and a temperature-sensitive element are laid in the flute prepared in advance and immured.
The cable in a floor is filled in with a coupler in the thickness 3-5 see
The temperature regulator is usually established after fulfilment in all painting and decorating.
To include system it is possible only after complete drying of a coupler, approximately in 30 days.
At fulfilment of all transferred requests on stacking of a cable the thickness of a floor with the cover laid on it, for example a tile, makes not less than 5 see But quite often at repair of separate premises in apartment it is impossible to lift a floor on such height as then between other premises and repaired there will be a step. Specially for manufacturing of a warmed floor by thickness of 1,5-2 sm (unlike 5 sm in the previous example) firm DE-VI manufactures cables DTIP-10 with the reduced specific capacity. These cables are displayed on the concrete basis the same as also cables DTIP-18 (from the previous example), but a step of their stacking in connection with a smaller specific capacity more often, that allows to reduce a thickness of a coupler accordingly. Actually the floor covering can be stacked directly on a cable.
Thus, the floor "will grow" only for diameter of a cable plus a thickness of cover together with a glue layer. As the coupler in this case is executed thin, thermal protection use is undesirable because of low prochnostnyih properties of received "pie". But even in the absence of a heat insulator actually all warmly, allocated with a cable, will go on the shortest way through a floor covering, and through the bottom concrete plate only insignificant part of heat will be lost. Cable which has recently appeared in our market, so-called «DevimatTM» easier keeps within. It represents thin (diameter 2,7 mm) a cable in advance laid in plastic armaturnuyu a grid. «DevimatTM» it is displayed directly on a concrete plate and it is rubbed clean by a gluing solution, on a plate the floor covering keeps within. In case of tile application the general thickness of such floor makes 1,5-2 sm that is obviously enough for any repaired premise.

HOW TO STACK ELECTROHEATING CABLES IN THE BATHROOM AND ON KITCHEN
Cable electric systems of heating can be divided into 2 groups: systems of heating of premises and system of comfortable heating. These systems from each other only type of a used temperature regulator and a specific capacity per unit of the area differ.
With what to begin the system warm, or comfortable, a floor in a bathroom or on kitchen? From account of necessary capacity of a cable. At complete heating capacity settles up starting with 120 Vt, and at comfortable heating from 80 Vt on each square metre of your premise. The cable "Deviflex DTIP-18" keeps within on previously prepared concrete basis (an old concrete floor) zigzags. Thus it is necessary to exclude contact of separate threads of a cable with one another.
At once it is necessary to be stipulated, that such variant of stacking of a cable is applied, when you do not wish to lift floor level considerably. If there is a possibility to offer in several centimetres of height for the sake of economy of heat and an electricity on an old floor the layer teploizolyatsionnogo a material at first keeps within, for example dense ekstrudirovannogo polyfoam or poliuretana. Then over a thermal protection the material with good heat conductivity, for example a building aluminium foil, and already over it – a cable keeps within. It is done to exclude any contact of a cable to a heat insulator. The cable at work heats up, and if it will be surrounded with a thermal protection layer, the probability of an overheat and failure is great.
Upon termination of stacking over a cable the concrete coupler of 3-4 sm is filled in with thickness and already on it new floor cover keeps within. It can be linoleum, kovrolin, the ceramic tile, a parquet. In the latter case the thickness of a tree should not exceed 20 mm. The thicker the concrete coupler, the will be distributed more uniform warmly on a floor surface. Between cable threads on distance about 50 sm from a wall the gauge of temperature which is connected to a temperature regulator is established. Do not forget to place the gauge in a tube that in need of it it was possible to extract easily. The temperature regulator «Devireg», possessed on a wall as the usual switch, should be at level of 1,2-1,4 m from a floor. He allows to establish and maintain invariable temperature of heating of a surface.
Some words and about the cable «Deviflex DTIP-18» are necessary to tell. Outwardly it looks as a usual electric wire with isolation of red colour. On the one hand it has the so-called cold end which is connected to a temperature regulator. With other – trailer muftu. A cable strong, ekranirovannyiy, with external isolation from PVC. All muftyi are absolutely tight, that allows them not to be afraid of a moisture. The cable and a temperature-sensitive element are connected to a temperature regulator. A system food – from an electric network with pressure 220 Century
Specially for the outside areas and uninhabited premises it is intended odnozhilnyiy ekranirovannyiy a cable «Deviflex DSIG-20» which differs from the aforesaid only availability of two cold ends.
After closing-up resistance of a heating vein of a cable and resistance of isolation are measured, and to system it is possible to make a food. Here it is better to trust in the qualified electrician as connection to an electric network is required. Having carried out connection, it is possible to include system. The regulator handle exhibits the necessary temperature of a floor which the system will support with accuracy 0,1-0,4°S. At desire it is possible to disconnect heating by one pressing of the button of the switch.
Electric cable systems of complete heating differ type of gauges of a temperature regulator on which the floor temperature is exhibited not, and air temperature indoors. Optimum distribution of heat – 24°S on a floor, 20°S at level of human growth and 18°S at a ceiling – creates conditions of a special cosiness. All surface of a floor, therefore heat besides, heats up is given in regular intervals so, are absent konvektsionnyie the streams which are carriers of a dust and pathogenic microflora. Such system established in pool, will allow to go on a tiled floor without risk to slip and fall, after all water on warm to a floor fast dries up.
All temperature regulators "Devireg" electronic, with a relay exit, are calculated for load of 2-3,5 kw. Besides, there are the programmed models of the temperature regulators allowing automatically to change temperature depending on the set program. It is very convenient, as the temperature will be changed automatically depending on your requirements, for example to go down at night and to increase by the morning, and without your daily interference! Except convenience, it gives the chance to save to 25 % of the electric power going on heating of a premise. Such temperature regulators can be united in a local network and to operate them by means of the computer. It is very convenient for houses where it is a lot of rooms.
Important advantage of systems of heating of floors or complete heating are their high reliability and safety for the person. For this reason cables "Deviflex" completely ekranirovanyi. It supplies your safety even at mechanical damage of three-layer isolation of a cable. And that fact, that "Deviflex DTIP-18" is strong, excludes influence on your health such maloizuchennyih the phenomena, as electric or magnetic fields. The 10-year-old warranty speaks about reliability of such cable also. Actual term of its service makes 30-50 years.M. OF NIGHTINGALES Source: the Newspaper "Building" #11 (2004) heading “Stroyinform”

It is introduced: on May, 15th, 2004

O methods of fastening of heating cables Deviflex
For installation of heating cables deviflex ™ it is recommended to use an assembly tape devifast ™. A steel tape stack with step 50-100 the tape Cost on the average see makes 1-2 m on 1 m І the areas. Krepit a tape it is possible in any method — dyubelyami, nails, glue, etc. the Heating cable can be fixed...
O methods of fastening of heating cables Deviflex
For installation of heating cables deviflex ™ it is recommended to use an assembly tape devifast ™. A steel tape stack with step 50-100 the tape Cost on the average see makes 1-2 m on 1 m І the areas. Krepit a tape it is possible in any method — dyubelyami, nails, glue, etc. the Heating cable can be fixed...
O methods of fastening of heating cables Deviflex
For installation of heating cables deviflex ™ it is recommended to use an assembly tape devifast ™. A steel tape stack with step 50-100 the tape Cost on the average see makes 1-2 m on 1 m І the areas. Krepit a tape it is possible in any method — dyubelyami, nails, glue, etc. the Heating cable can be fixed...
Ustroystvo a warm floor
In some premises: in a bedroom, a bathroom completely not superfluous the system of a warm floor will be children's. It happens two kinds: electric and water. On a primary coupler the special electric cable or the pipeline connected to system of giving of hot water keeps within on all area of the premise, accordingly, and already the definitive coupler...
Elektricheskiy floor heating
Basic element of such system is the multilayered heating electricity cable which temperature is regulated by means of the thermostat. As a rule, it does not exceed 50°S, that completely excludes danger of a fire and allows to use any floor covering. The wire is mortgaged by a snake in the ordinary concrete coupler which thickness depends on a number...
Ustroystvo warm floors
QUESTION: Of what the warm floor and in what its basic advantage consists? In what difference of a warm floor from ordinary classical heating?The ANSWER: the Warm floor represents the system consisting of following elements: a thermal protection, an assembly tape, a heating element, the gauge of temperature of a floor and a temperature regulator. Thermal protection stacking is obligatory...
Oborudovanie for modern heating
Among independent systems of heating direct stationary electric heating wins the increasing popularity. Direct stationary electroheating is understood as a set of heating devices which will transform the electric power directly to heat without intermediate heat-carriers. This heating equipment is connected to a network through system of the temperature regulators, allowing to change and program heating modes in a wide...
Cistemyi floor heating
At use of a traditional variant of the system of heating when heating devices are possessed along walls, form konvektsionnyie streams in which nagretyiy air is lifted upwards, gradually giving heat and cold falls to a floor. The cold floor creates sensation of discomfort.That the person felt cosy, the floor temperature should be close to comfortable temperature of air indoors....
Nezamutnennyiy a sight with heating
 Water steam which is often formed in a bathroom, not only settles on a mirror surface, but also negatively affects mirror cover - glass is covered in due course with stains, grows turbid - and the mirror should be changed. Deviheat ™ is the unique heating system made in Denmark, including a heating cable, elements of fastening for it and...
Pravilnoe heating
More and more in our houses electric heating is used. If is more exact, - direct stationary electric heating. For someone "to be heated by an electricity" it seems to waybills. However it, if on-starinke - powerful tenami and reflectors. Actually, modern methods of "electroheating" are economic enough and favourable.ADVANTAGES UNDER THE LISTDirect stationary electric heating is understood as a...
Pravilnoe heating
More and more in our houses electric heating is used. If is more exact, - direct stationary electric heating. For someone "to be heated by an electricity" it seems to waybills. However it, if on-starinke - powerful tenami and reflectors. Actually, modern methods of "electroheating" are economic enough and favourable.ADVANTAGES UNDER THE LISTDirect stationary electric heating is understood as a...
Tehnologiya a thin warm floor
At the system of a warm floor in an apartment house there are restrictions which it is necessary to consider. For economic work not to heat to neighbours a ceiling, the good thermal protection is necessary. However, in the presence of a thermal protection layer the system of a coupler of a sufficient thickness, with good bearing ability is required,...
Sistema heating «a warm floor»
Question: What for «warm floors» are necessary?The answer: For uniform comfortable heat. Traditional systems of heating with the localised heaters (in particular, radiators) create in premises strong konvektivnyie streams which promote cooling of the bottom layers of air and an overheat of the top. The sensation when like and it is not cold, and feet — merznut is familiar to...